張貼者:2010年8月12日 下午10:58未知的使用者
[
eddie liu 已於 2012年8月8日 上午12:57 更新
]
 COMM-DRV/NTyongyu 是串行通信的高速核心驅動程序。
開發商:Willies' Computer Software Co 原廠網址: http://www.wcscnet.com/CdrvNBro.htm更新日期:2011/05/29 採購正式版、大量授權報價、技術支援、軟體諮詢、委託採購、詢問報價請來電 02-29299388 分機16 , 來信service@orderble.com,或 點我-----------------------------------------------------------------------------
COMM-DRV/NT 是完美的應用在下列任何一種適用於: 需要高速和/或可靠的串行通信在一個或多個端口同時進行。 需要多點協議的支持(485)。 需要9位協議的支持。 支持內置的串行端口在主板(串口COM1,COM2端口,等等)。 支持非智能的PCI及多端口的ISA卡w/16x50個 UART。 需要較大的FIFO支持的16650系列的UART。 需要清晰支持硬件流控制直接內建 到UART的。 需要時間沖壓字節微秒的決議。 需要回調的活動,包括國家的調製解調器的信號,路線錯誤,斷線檢測,和其他事件。 需要有您的16位MS - DOS應用程序運行在Windows 2003,Windows XP和Windows 2000或Windows NT。
|
COMM-DRV/NT is perfect for applications where any of the following applies: Need for high speed and/or reliable serial communication on one or more ports concurrently. Need for multidrop protocol support (RS485). Need for nine-bit protocol support. Support for built in serial ports on motherboard(COM1, COM2, etc.). Support for non-intelligent PCI & ISA multiport cards w/16x50 UARTs. Need for support for the larger FIFOs of the 16650 family of UARTs. Need for crisp support of hardware flow control built directly into UART. Need for time stamping bytes with microsecond resolution. Need callbacks on events including state of modem signals, line errors, break detection, and other events. Need to have your 16 bit MS-DOS application run under Windows 2003, Windows XP, Windows 2000, or Windows NT.
|
|
|